Display Full Text | Download Full Text
2.55 MB PDF file

Degree

PhD, University of Cincinnati, Arts & Sciences : Physics, 2001.

Abstract

This thesis presents the design, fabrication, and testing of novel MEMS pressure and temperature sensors fabricated on optical fiber end faces. A simple micromachining process compatible with MEMS was developed in fabricating sensors directly on optical fibers. The pressure sensor configuration involves anodic bonding of a piece of an extremely thin silicon wafer onto the fiber end face over a cavity etched in the central portion of the fiber end face. Final device diameter is thus the same as that of the optical fiber. The temperature sensor is based on anodically bonding a thin piece of silicon onto the fiber end face.The pressure sensors were fabricated on 400 um diameter fibers while temperature sensors were fabricated on both 200 and 400 um diameter fibers. Pressure measurements were made over the 14 to 80 psi range while temperature measurements were made over the 23 to 300 Celcius range. Pressure sensor sensitivities of 0.1 mV/psi and 0.2 mV/psi were obtained. The pressure sensors were designed with cavity diameter d=150 um, and cavity depth h=0.640 um. Diaphragm thickness for the two sensors were t=7.1, and t=3.4 um. Higher sensitivity was achieved by design of a sensor with the thinner diaphragm. A sensor array fabrication effort demonstrated that our micromachining process could be extended to simultaneous processing of an array of fibers. The temperature sensor was fabricated by bonding 3.1 um thick silicon onto the fiber end face. An oxidant-resistant encapsulation scheme for the temperature sensor was proposed, namely aluminum coated silicon nitride (Al/Si3N4). The uncoated side of silicon was bonded to a fiber end face using the anodic bonding method. The measured values of kf=(lambda)-1x(dlambda/dT) for capped and uncapped sensors were kf=(7.5±0.6)x10-5/Celcius, and kf=(7.2±0.1)x10-5/Celcius respectively. The measured kf value for the uncapped sensor is equal to that which was determined using the published material properties for crystalline silicon (kf=7.9x10-5/Celcius) within measurement uncertainty. The micromachining process developed for micromachining fiber end faces along with the bonding of silicon to fiber end faces can be extended to fabrication of other MEMS based micro-optic devices where fiber optic interrogation is advantageous.

Keywords

PRESSURE SENSOR; TEMPERATURE; MEMS; FIBER OPTIC SENSOR; FABRY-PEROT SENSOR

Advisor

Howard E. Jackson

Document number: ucin997987327
Permalink: http://rave.ohiolink.edu/etdc/view?acc_num=ucin997987327

★

This ETD has been downloaded 2818 times (through March 2013)

This ETD was one of the top fifty most frequent downloads of 2001, 2003 and 2004.